Test Oil - Hartridge CRi-PC Operating And Servicing Manual

HARTRIDGE LIMITED
2.7

Test oil

Refer to Figure 2.6
The tank should be filled via the left side panel.
Loosen the four panel retaining screws (A) and lift off the side panel.
Remove the three panel retaining nuts (B) and lift off the tank access panel.
Fill the tank with clean test fluid to Shell ISO 4113 specification through the aperture in the
side of the test stand.
The fill level can be observed on the tank drain tube on the bracket below the tank access
aperture. The window indicates the maximum & minimum levels and is also visible when all
panels have been replaced.
Replace the tank access panel and the left side panel.
HL037 (EN), Issue 13, AT714, 05/14
THIS IS AN UNCONTROLLED DOCUMENT downloaded by Lukas Matuska on 16 Feb 2016
Any technical intervention requires certified Hartridge training. Contact Hartridge Ltd for details.
WARNING! HIGH PRESSURE FLUID SPRAYS CAN CAUSE
SERIOUS INJURY OR DEATH. COMMON RAIL SYSTEMS OPERATE
AT EXTREMELY HIGH PRESSURES.
DO NOT ATTEMPT TO OPEN THE TANK ACCESS PANEL WHILE
THE SYSTEM IS RUNNING.
CRi-PC Operating and Servicing Manual
17