Measure Injector Coil Resistance (If Selected In The 'Start Test' Dialog) - Hartridge CRi-PC Operating And Servicing Manual

CRi-PC Operating and Servicing Manual
If you want to save the test results you can enter your name, a customer reference, and the
injector serial number.
You have the option of skipping the resistance test by checking the 'Skip Resistance Test'
box. This will prevent the need to do a resistance check before each injector test (clicking F9
from the main screen will allow a resistance test to be performed when required). If a
resistance test is required before each injector test, leave the box unchecked
Select the injector Manufacturer / Type and the Testplan / Part Number required, then select
either Manual or Automatic test & then click OK.
NOTE:
Example test plans will be provided for each manufacturer. These give typical test parameters
but do not give test result limits. The 'example' test plans can be used to help create
individual test plans for specific injector part numbers. See Section 4.5.

Measure Injector Coil Resistance (if selected in the 'Start Test' dialog).

4.3.2
Refer to Figures 4.8 and 4.9.
The injector solenoid resistance should be measured before any other tests to help avoid
system trips due to faulty solenoids. This test should always be the first test step of all
testplans. On-screen dialogs will prompt the operator to connect the resistance measurement
cable for the specific type of injector to the lower socket (1) in the Injector test area (4 way
connector).
Resistance measurement is only valid for solenoid coil injectors, not for piezo injectors.
NOTE
78
THIS IS AN UNCONTROLLED DOCUMENT downloaded by Lukas Matuska on 16 Feb 2016
Any technical intervention requires certified Hartridge training. Contact Hartridge Ltd for details.
Figure 4.7 Start Test Dialog
HARTRIDGE LIMITED
HL037 (EN), Issue 13, AT714, 05/14