Status/Diagnostic Screen - Hartridge CRi-PC Operating And Servicing Manual

CRi-PC Operating and Servicing Manual
Shows the current step of the testplan plus any comments associated with the current step,
also the conditions applied to the injector for that step: Fluid Supply Temperature; (Rail)
Pressure Demand; Injection Speed; Pulse Width and Backleak Pressure Demand.
The 'Live' measured Supply Temperature and Rail Pressure are displayed too.
Area 3:
Measured / calculated parameters -
Shows the current measured parameters for the test step: Supply temp; Injector coil
resistance; Rail pressure; Injector response time; Injector response variation; Backleak flow;
Backleak temperature; Backleak pressure; Injector delivery and Injector delivery variation.
4.2.4

Status/Diagnostic Screen

If the F10 function key turns red a problem has been detected with the system. Clicking the
F10 key will open the Status/diagnostic screen. On this screen the status of all machine
interlocks & controls plus the pump and injector control boards can be observed.
An interlock fault will stop certain machine functions from operating and the cause should be
investigated.

A indicates that the interlock or control board is OK.

A indicates that the interlock or control board has tripped.

Note that a against an item in the machine status window does not necessarily indicate a
fault, it simply indicates that particular item is not active at the present time.
A tripped Pump PCB or Injector PCB can be reset by clicking the appropriate Reset button
on-screen.
74
THIS IS AN UNCONTROLLED DOCUMENT downloaded by Lukas Matuska on 16 Feb 2016
Any technical intervention requires certified Hartridge training. Contact Hartridge Ltd for details.
HARTRIDGE LIMITED
HL037 (EN), Issue 13, AT714, 05/14