Controls - Hartridge CRi-PC Operating And Servicing Manual

HARTRIDGE LIMITED
3.8

Controls

Refer to Figure 3.4.
1.
2.
3.
4.
HL037 (EN), Issue 13, AT714, 05/14
THIS IS AN UNCONTROLLED DOCUMENT downloaded by Lukas Matuska on 16 Feb 2016
Any technical intervention requires certified Hartridge training. Contact Hartridge Ltd for details.
Emergency stop – pressing the button stops the CR pump, dumps the CR pressure,
disables the air supply and so stops the fluid system. This button should not be used
as a general stop for the test bench; its use is intended for emergency situations.
Clamp pushbutton – press to move the clamping mechanism upward, toward the
injector. The button has to be held to maintain movement. When the clamping
mechanism reaches its mechanical stop the button may be released.
Unclamp pushbutton – press to move the clamping mechanism downward, to
unclamp the injector. The button has to be held to maintain movement.
CR pump motor start – press 'I' to start the CR pump, after the initial
starting sequence the pressurising system is enabled. The motor will not start if the
injector is not clamped.
CR pump motor stop – Press 'O' to stop the CR pump motor
2
1
3
Figure 3.4 Controls
CRi-PC Operating and Servicing Manual
4
5
25