Creating/Editing/Saving Testplans; General; Parameters - Hartridge CRi-PC Operating And Servicing Manual

CRi-PC Operating and Servicing Manual
4.5

Creating/Editing/Saving Testplans

4.5.1

General

Pressing F6 in the main screen will call up the Testplan Editor (Figure 4.2).
The Editor uses the following standard Microsoft® Windows® commands.
File - New, Open, Close, Save, Save As, Print, Print Setup, Print Preview, Exit, Find/Replace
Edit – Undo, Cut, Copy, Paste
View - Toolbar, Status Bar
Window – New Window, Cascade, Tile, Arrange Icons
Help - Help Topics, About CPE Editor
To create a new testplan, open one of the example testplans, then use the "Save As"
command to save with a different filename. The test step values can then be changed as
required.
We advise you NOT to change the example testplans supplied as this will maintain a
NOTE:
consistent base to refer back to if needed.
Selecting one of the numbered test steps in the left hand column and then clicking the right
hand mouse button will display the Insert/Delete menu. From this a new step may be inserted
before or after the selected step or the selected step may be deleted. Refer to Figure 4.12.
4.5.2

Parameters

Refer to Figure 4.13.
Scrolling horizontally to the right reveals the parameters that cannot be seen on the screen
(column 6 onwards).
84
THIS IS AN UNCONTROLLED DOCUMENT downloaded by Lukas Matuska on 16 Feb 2016
Any technical intervention requires certified Hartridge training. Contact Hartridge Ltd for details.
Figure 4.12 Insert/Delete Menu
HARTRIDGE LIMITED
HL037 (EN), Issue 13, AT714, 05/14