Hartridge CRi-PC Operating And Servicing Manual page 8

CRi-PC Operating and Servicing Manual
General Warnings
Ensure good levels of lighting for safe, efficient equipment operation.
Accidents can occur to unauthorised personnel during testing. Untrained person(s)
must not be present in the test area when the equipment is operating. Only
qualified personnel are to operate this equipment.
This equipment contains electrostatic sensitive devices. Observe the necessary
precautions for handling electrostatic discharge sensitive devices. Do not touch
printed circuit boards and associated electronic connections and components.
Gloves conforming to standard BS EN 407:1994 must be worn when handling
parts after testing which may be hot.
Safety footwear must be worn in the test area at all times. Injury to the feet may be
sustained in the event that equipment under test (during loading or unloading) or
test stand covers are dropped.
Burns will occur to the hands if certain parts of the test stand or equipment under
test are touched. Keep hands away from the calibration fluid heater element and
injector or high pressure pipes after periods of extended running.
Severe injury can be caused by slipping on spilt oils or fluids. All spillage of fluids
in the test area must be dealt with immediately.
There must be no naked flames. Smoking in the vicinity of the equipment is strictly
forbidden. Potentially flammable vapours are present in the test stand and ignition
is possible although unlikely.
Arc welding equipment must not be operated within 5 metres of the test stand.
The electrical supply to welding equipment must be provided from a remote
isolating transformer. Arc welding can disturb the measuring circuit.
6
THIS IS AN UNCONTROLLED DOCUMENT downloaded by Lukas Matuska on 16 Feb 2016
Any technical intervention requires certified Hartridge training. Contact Hartridge Ltd for details.
HARTRIDGE LIMITED
HL037 (EN), Issue 13, AT714, 05/14