Hartridge CRi-PC Operating And Servicing Manual page 9

HARTRIDGE LIMITED
HL037 (EN), Issue 13, AT714, 05/14
THIS IS AN UNCONTROLLED DOCUMENT downloaded by Lukas Matuska on 16 Feb 2016
Any technical intervention requires certified Hartridge training. Contact Hartridge Ltd for details.
Ensure that the servicing requirements and intervals as set out in the Maintenance
section are adhered to. Operate and service this equipment only if competent to
do so. Carry out regular inspections to make sure all high pressure connections
are tight and safe.
High fluid pressures exist within the test stand. Do not run the test stand without
all cover
Fluid sprays, especially from leaking high pressure pipes and seals, will cause
high pressure injection through the skin which can result in fatal injury.
Use calibration fluid and lube oil of the correct specification only. Obtain the
manufacturers Health & Safety Data Sheets and follow the advice given therein.
Prolonged and repeated contact with oil products, ingestion or excessive and
prolonged inhalation of oil mists can be detrimental to health. Use an appropriate
barrier cream.
Make sure there is adequate ventilation. Oil vapour may be released from hot
fixtures or high pressure leaks. The specific directions in Health & Safety Data
Sheets must be adhered to.
High Voltage!
Isolate and lock the electrical supply off before performing any maintenance
operations. Do not work on electrical equipment while voltage is supplied.
Be aware that the computer and monitor are supplied separately from the test
stand 3 phase supply and may therefore still be powered when the test stand 3
phase supply is switched off.
CRi-PC Operating and Servicing Manual
panels fitted.
7