HARTRIDGE LIMITED
4.2.5
Red Status Indicator
System errors are indicated by a small box with a Red Status indicator at the bottom of the
screen. To clear this, click on the Red Status indicator, note the error(s) listed and click on the
'Clear All' button.
NOTE:
This is normal.
4.3
Test Setup and Method
The basic parameters that will establish the condition of a CR injector are:
"Example" testplans are provided for each manufacturer. These contain the basic electrical
characteristics for that manufacturer's injector and typical demand settings for various
conditions. They do not contain expected results values as these will be specific to each
injector part number. "Example" testplans can be used as a basis for creating dedicated
testplans for specific injectors.
4.3.1
Load a Testplan
When you first enter the CR Injector Test screen it will be mainly blank. You must load a
testplan to start testing.
To load a testplan for the relevant injector manufacturer, first press F1 (Start Test). This will
display the Start Test dialog (Figure 4.7).
HL037 (EN), Issue 13, AT714, 05/14
THIS IS AN UNCONTROLLED DOCUMENT downloaded by Lukas Matuska on 16 Feb 2016
Any technical intervention requires certified Hartridge training. Contact Hartridge Ltd for details.
A Red Status Indicator will appear if the 3 phase supply is turned off and the PC is left on.
Figure 4.6 Red Status Indicator
Spray Pattern (checked on Testmaster)
Delivery vs. pressure vs. pulse width
Backleak flow (dynamic and static)
Response Time
CRi-PC Operating and Servicing Manual
77