Operation; Guidelines For Safe Working Practice; Software Overview - Hartridge HK900 Operating Manual

HARTRIDGE LIMITED

4. Operation

4.1 Guidelines for Safe Working Practice

4.2 Software Overview

The HK900 kit is controlled through the AVM2 PC software; Magmah version 33 or later is required (a
software upgrade kit must be ordered separately if your AVM2 does not have version 33).
HL030(EN), Issue 1, June 2005
THIS IS AN UNCONTROLLED DOCUMENT downloaded by Lukas Matuska on 16 Feb 2016
Any technical intervention requires certified Hartridge training. Contact Hartridge Ltd for details.
WARNING! HIGH PRESSURE FLUID SPRAYS CAN CAUSE SERIOUS
INJURY OR DEATH.
COMMON RAIL SYSTEMS OPERATE AT EXTREMELY HIGH PRESSURES. IF
USED AS INSTRUCTED THE TEST KIT WILL RELIEVE ANY HIGH PRESSURE
WHENEVER THE GUARD DOORS ARE OPENED.
DO NOT ATTEMPT TO BYPASS THE PRESSURE DUMP VALVE OR THE
SAFETY INTERLOCK.
WARNING! THE CONTROLS IN THE HK900 KIT HAVE BEEN DESIGNED TO
WORK WITH ONE OF THE FOLLOWING CR PUMPS:
BOSCH CP1 (WITH PCV)
DO NOT ATTEMPT TO USE ANY OTHER TYPE OF PUMP WITH THE KIT.
Always start the system running at a low pressure and visually check for any leaks
before setting higher pressures. This particularly applies having just mounted a
system, or having just replaced a component.
Do not open the guard while the system is running. Wait for the test bench drive
to stop and for the pressure to decay to a lower level before opening the guard.
The pump, injectors, and delivery lines to the metering unit will become very hot
after running. Wear protective gloves if handling immediately after use.
Operating Manual
OR SIEMENS
17