Siemens Pointek CLS200 Operating Instructions Manual page 54

Technical data
9.1 Pointek CLS200/300
Process
Note
Please see Pointek CLS200 standard pressure versus temperature curves (Page 60) and
Pointek CLS300 standard pressure versus temperature curves (Page 63).
relative dielectric constant (ε
Temperature at process connection
CLS200 temperature:
• Without temperature extend-
ed shaft:
• With temperature extended
shaft
CLS200 pressure (vessel):
• rod version
• cable version
• sliding coupling version
CLS300 temperature:
• Without temperature extend-
ed shaft
• With temperature extended
shaft
• High temperature version
• CLS300 pressure (vessel):
At process connection
1)
With ATEX approval: Depends on surface temperature and temperature and temperature
2)
class. See Flame Proof and Dust Ignition Proof (CLS200) (Page 71)and Flame Proof and Dust
Ignition Proof (CLS300) (Page 74).
Approvals (verify against product nameplate)
CLS200
General Purpose
Dust Ignition Proof
Flame proof/Explosion proof
54
) 1.5 minimum
r
1)2)
–40 to 85 °C (–40 to 185 °F)
–20 to 85 °C (-4 to +185 °F) with option FFKM seal O-ring
–40 to 125 °C (–40 to 257 °F)
–20 to 125 °C (–4 to 257 °F) with option FFKM seal O-ring
–1 to 25 bar g/–14.6 to 365 psi g (nominal)
–1 to 10 bar g/–14.6 to 150 psi g (nominal)
–1 to 10 bar g/–14.6 to 150 psi g (nominal)
1)2)
–40 to 85°C (–40 to 185°F)
–20 to 85 °C (-4 to +185 °F) with option FFKM seal O-ring
–40 to 200°C (–40 to 392 °F)
–20 to 200 °C (–4 to 392 °F) with option FFKM seal O-ring
–40 to 400 °C (–40 to 752 °F)
–1 to 35 bar g/–14.6 to 511 psi g (nominal)
CSA, FM, CE
ATEX II 1/2D, IIIC
CSA/FM Class II, Div. 1 Gr. E, F, G Class III
INMETRO
ATEX II 1/2G, IIC
CSA/FM Class I, Div. 1 Gr. A, B, C, D
INMETRO
Pointek CLS200/CLS300 standard
Operating Instructions, 05/2021, A5E47827796-AA