Process Cautions Cls200 - Siemens Pointek CLS200 Operating Instructions Manual

5.2.4

Process cautions CLS200

NOTICE
• The maximum allowable torque on a horizontally installed rod is 15 Nm.
• Keep unit out of path of falling material, or protect probe from falling material.
• Consider material surface configuration when installing unit.
• Tensile load must not exceed probe or vessel rating (See Tensile(max) under Electrode -
• Avoid areas where material build up occurs.
Pointek CLS200/CLS300 standard
Operating Instructions, 05/2021, A5E47827796-AA
CLS200 Standard table in Pointek CLS200/300 (Page 50)).
Installation
5.2 Pointek CLS200
19