Siemens Pointek CLS200 Operating Instructions Manual page 104

Capacitance switches

Hide thumbs Also See for Pointek CLS200:

Table of Contents

Shortening the cable

E.1 Pointek CLS200 Standard, cable version

11.Prepare the leads for soldering, and if heat shrink is used to insulate splices, remember to

slip on the heat shrink before soldering the leads.

12.Make the solder connections and position the heat shrink to completely insulate each solder

connection before shrinking it.

①

②

③

13.Remove any excess cable core, if necessary.

14.Apply PTFE type tape/sealant to all threads.

15.Add a pre-twist to the wires before screwing the probe sleeve and lower probe assembly

together: hold the probe sleeve still, and gently turn the lower probe assembly counter-

clockwise about 5 full turns. This avoids the wires being broken when the probe and probe

sleeve are assembled.

16.Screw the lower probe assembly clockwise into the probe sleeve, and tighten it with a 17

mm (0.67") wrench.

Pointek cls300