Single Line Telephones - NEC SL1000 Features And Specifications Manual

SL1000
Description
The system is compatible with Dial Pulse and DTMF analog single line telephones (SLTs). Single line
telephone users can dial codes to access many of the features available to multiline terminal users.
With single line telephones, you can have your system simulate PBX type operation.
There are 128 single line telephones available (note that this number may be restricted due to system
power requirements).
S
When installing single line telephones you must have:
• A port on a 408M-A1/408E-A1/008E-A1 for each single line telephone installed.
• If you have DTMF sets, at least one block reserved on the CPU for analog extension DTMF recep-
tion.
DTMF Dial Out Timer Added
A program is added for DTMF dialing, Program 20-03-07 : System Options for Single Line Telephones-
Trunk Call Dial Forced Sending Start Time (Forced Dial). When Program 20-03-03 : System Options
for Single Line Telephones - SLT DTMF Dial to Trunk Lines is set to 0 (receive all digits before
sending), the system follows the timers in Program 20-03-04 and Program 20-03-07.
The timer in Program 20-03-04 System Options for Single Line Telephones - Dial Sending Start Time
for SLT or ARS resets when the user dials another digit.
The timer in Program 20-03-07 System Options for Single Line Telephones - Trunk Call Dial Forced
Sending Start Time (Forced Dial) does not reset when a digit is dialed. The user must finish dialing all
the digits before this timer expires (entries: 0~64800 seconds, default: 0).
Conditions
• Dial Pulse single line telephones cannot access any feature that requires the user to dial # or
• A single line telephone can initiate an Internal Zone page, but cannot receive an Internal Zone Page.
• When a Ring Group call rings a single line station, the BLF indication shows busy.
• Stutter Dial Tone is supported to Single Line Telephones for Voice Mail Message Waiting.
• The 1632M KSU has 20 resources for DTMF receiving and Dial Tone detection. When a 1632ME
EXP with EXIFE-C1 is installed there are 32 resources available.
• When Program 10-09-01 is set to 0 (Common) and Program 14-02-10 (Caller ID) is set to 1 (Yes), all
DTMF/Dial Tone Detection resources are always allocated to analog trunks, not analog extensions.
However, if Program 14-02-10 (Caller ID) is set to 0 (No), all DTMF/Dial Tone Detection resources
can be used for both analog trunks and analog extensions.
Default Setting
Single line telephones function as soon as they are installed and properly programmed.
System Availability
Terminals
Analog Single Line Telephones(DP and DTMF type)
1-462

Single Line Telephones

Single Line Telephones
ISSUE 1.0
.
*