NEC SL1000 Features And Specifications Manual page 499

ISSUE 1.0
Trunk Disconnect Continue/Disconnect Codes
Program
Number
14-01-25 Basic Trunk Data Setup - Continued/Discontinued
Trunk-to-Trunk Conversation
20-28-01 Trunk to Trunk Conversation - Conversation Continue
Code
20-28-02 Trunk to Trunk Conversation - Conversation Discon-
nect Code
20-28-03 Trunk to Trunk Conversation - Conversation Continue
Time
24-02-07 System Options for Transfer - Trunk-to-Trunk Transfer
Release Warning Tone
24-02-10 System Options for Transfer - Disconnect Trunk-to-
Trunk
25-07-07 System Timers for VRS/DISA - Long Conversation
Warning Tone Time
25-07-08 System Timers for VRS/DISA - Long Conversation
Disconnect Time
80-01-02 (35) Service Tone Setup - Basic Tone Number
Operation
Method A - Tandem Trunking from Conference
To set up a Tandem Call:
1. Place or answer first trunk call.
2. Press Conf softkey or DND/CONF key.
3. Place or answer second trunk call.
4. To set up the tandem call, press Conf softkey or DND/CONF key twice.
This sets up a Conference between you and both outside parties.
5. Press Transfer.
- OR -
Press Hold and dial #8 or the service code set for Unsupervised Conference/Tandem Trunking in
Program 11-12-57.
The line keys for the trunks blink green as long as the Unsupervised Conference continues.
To end the Tandem Call:
1. Press either flashing line key.
The line keys light steadily (green). You can listen (i.e., monitor) to the call or rejoin the conversation,
based on the setting in Program 20-13-10.
2. Press Speaker or hang up.
If Program 20-13-10 is set to 0, the Conference ends and the line keys go out.
Features and Specifications Manual
Program Name Default
0
not assigned
not assigned
0 (seconds)
1800 (seconds)
0 (seconds)
30 (seconds)
15 (seconds)
0~33
0 = No Tone
33 = Default Time Slot
SL1000
T
1-491