NEC SL1000 Features And Specifications Manual page 145

ISSUE 1.0
1. Press Conf (Transfer) or Conference key (Program 15-07 or SC 851 : 07).
2. Dial Split service code (894 ).
Repeat this procedure to alternate between the remaining parties in the Conference. Press the Conf soft-
key or press Conf twice to set up the Conference again.
Single Line Telephone
1. Hookflash and dial 894 .
Repeat this procedure to alternate between the remaining parties in the Conference. Hookflash twice to
set up the Conference again.
To drop an outside call from the Conference:
1. Press Hold to place the conference call on hold.
2. Hang up.
The lines involved in the Conference ring back separately to the telephone.
3. Answer and disconnect the unwanted outside call.
4. To re-establish the Conference, answer the remaining call by pressing Conf after each call is an-
swered. Press Conf twice when all calls have been answered.
To exit a Conference without affecting the other parties:
Multiline Terminal
1. Hang up.
If you press Hold while on a call with two outside callers, the outside callers hear what is programmed in
Program 10-04-01.
Single Line Telephone
1. Hang up.
If you are not permitted to use Tandem Trunking, outside callers may hear Music on Hold.
To Barge-In to Conference Call:
1. Pick up the handset or press Speaker and dial the service code (default = 810 ).
If the telephone does not have the proper COS, a warning tone is sent. After the user hangs up, the system
automatically places a Callback to the extension.
2. Dial the extension number or press a DSS key of a telephone within a Conference call.
When a new call is added to the conference, an intrusion tone is heard by all parties in the Conference,
depending on system programming, and all display multiline terminals show the joined party. If a Con-
ference is not possible:
• the extension user hears a warning tone
• the DISA user is rerouted to the defined ring group
- OR -
The following steps are not available for DISA:
1. Dial the extension number of the internal party.
2. Dial the single digit service code, if programmed.
Instead of the single digit service code, the service code 810 can also be dialed at this point.
Features and Specifications Manual
SL1000
C
1-137