SECTION 5 (CONTINUED)
TOOLS AND HARDWARE REQUIRED
3/16"
(≈5 mm)
(2)
5.4
• Secure a Bolt (GDN) and a Washer (GDO) at one end of both Coupler Pins (GDZ).
GDN
5.5
• Position one of the Lifter Arms (ALS) as shown. Slide the
Coupler Pin Assembly through the outer frame of the
Handle. Continue sliding the Coupler Pin through the Lifter
Arm and the inner handle frame, then secure these parts
with the hardware indicated.
ALS
GDN (x4)
GDZ
GDO
!
• Fit this Washer (GDO) over
the Bolt (GDN) to secure the
hardware to the Coupler Pin.
GDO
ALS
GDZ (x2)
GDO (x4)
GDN
5.6
GDN
!
34
GDZ
GDO
• Repeat the previous step to secure
the remaining Lifter Arm (ALS) to the
other side of the Handle Assembly.
Start the Pin from the outside and
slide it inward.
ALS
GDO
GDN
• Fit this Washer (GDO) over
the Bolt (GDN) to secure the
hardware to the Coupler Pin.