Table of Contents
Advertisement
SECTION 1 (CONTINUED)
TOOLS AND HARDWARE REQUIRED
(1)
1.2
1.3
• Make sure the Pole Alignment Stickers are on the same side of the Pole assembly as the Pole Bracket. Slide the Top Pole (ALH)
onto the Middle Pole (ALF) as shown.
1.4
1.2
ATTENTION: THIS STEP CANNOT BE REVERSED!
• In order to seat the Poles, strike the end of the Pole
very hard fi ve to six times on a piece of scrap wood.
The Top Pole (ALH) should come down until it covers
the 4.5-inch pencil mark at the top of the Middle
Pole (ALF). It must go no further than the 5-inch
mark. If the Top Pole does not cover the 4.5-inch
mark at the top of the Middle Pole after seating, DO
NOT COMPLETE ASSEMBLY. Call our Customer Service
Department.
!
• Do not strike your feet with the
Alignment sticker
ALF
Pole sections, as serious injury
may occur.
ALH
!
6x
The Poles must be seated together! Even if the
Poles cover the slots before seating, they must be
struck on a hard surface five to six times! Failure
to seat the Poles correctly could allow the Poles to
separate during use, which could lead to serious
personal injuries or property damage.
6
WARNING
Advertisement
Table of Contents
