Table of Contents
Advertisement
SECTION 5 (CONTINUED)
TOOLS AND HARDWARE REQUIRED
5.10
• Slide the Actuator Clip (GDP) onto the Handle Bracket. Pull the tabs on each side of the Clip to bypass the slots in
the bracket as you slide it up against the plastic Handle. Hold the Clip as you perform the next step.
Tabs
5.11
• Line up the hole in the Gas Spring Actuator between the holes on the handle bracket (fi g. 1) and insert the
Handle Pin (GDQ) through the hole (fi g. 2). Slide the Actuator Clip (GDP) down over the Pin until the tabs snap into
the slots (fi g. 3).
1
Handle
Bracket
Actuator
GDQ (x1)
Notched side must
face up towards the
Gas Spring when
installed.
GDP
2
GDP
GDQ
GDP (x1)
37
Slots in the Handle
GDP
Brackets
3
GDP
Advertisement
Table of Contents
