Table of Contents
Advertisement
SECTION 4 (CONTINUED)
TOOLS AND HARDWARE REQUIRED
3/16"
(≈5 mm)
(2)
GDN (x2)
GDM (x1)
4.1
• Secure one Bolt (GDN) and Washer (GDO) to a Coupler Pin (GDM) at one end.
4.6
4.2
• Attach the Lower Extension Arms (AKE) to the Top Pole (ALH) with the hardware shown. If necessary, use a Rubber Mallet to tap
the Coupler Pin Assembly through the holes.
GDM
GDO (x2)
GDN
GDO
ABN
GOS
AKE
ABN (x2)
GDM
!
ABN
GOS
ALH
26
GOS (x2)
• Make sure the extension arms are oriented
with these holes toward the top of the pole.
GDO
GDN
!
• Fit this Washer (GDO) over
the Bolt (GDN) to secure the
hardware to the Coupler Pin.
Advertisement
Table of Contents
