Lifetime MAMMOTH Series Assembly Instructions Manual page 37

SECTION 5 (CONTINUED)
TOOLS AND HARDWARE REQUIRED
3/16"
(≈5 mm)
(2)
GOU (x1)
5.2
• Secure one Bolt (GDN) and Washer (GDO) to a Coupler Pin (GOU) at one end.
5.3
• Secure the Handle (AKI) to the Pole.
GDN (x2)
GDO (x2)
GDN
GDO
ABN
GOU
ABN (x2)
GOU
!
• Make sure to orient the handle
as shown, with the visible
screws facing the base.
ABN
33
GDO
GDN
!
• Fit this Washer (GDO) over
the Bolt (GDN) to secure the
hardware to the Coupler Pin.