SECTION 2 (CONTINUED)
TOOLS AND HARDWARE REQUIRED
1/2"
(≈13 mm)
(2)
CNC (x2)
2.9
• While on it's side, attach the fl attened end of the Pole Brace (ALI) to the Base (AJM) with the hardware shown.
Install the Chain (CNC) between the Washer and the Pole Brace. Only fi nger tighten the hardware for now.
AAM
ABD
CNC
View from underneath
2.10
• Repeat step 2.9 to install the remaining
Pole Brace (ALI) and Chain (CNC) to the
other side of the Base. Make sure the
unattached ends of the Pole Braces align
with the Bottom Pole as shown.
AAM (x2)
ABD
AAO
ABD (x4)
!
• The Chains require Cement Anchors to secure the
system to the ground. See the fi nal assembly section for
detailed instructions on installing the cement anchors.
AJM
ALI
15
AAO (x2)
ALI