Analog Devices ADSP-21262 EZ-KIT Lite Manual page 28

Installation Tasks
1-6
Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com.
Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from
Figure 1-1. EZ-KIT Lite Hardware Setup
3. Plug the provided power supply into
Visually verify that the green power LED (
that the two red reset LEDs (
and then go off, and, finally,
4. Connect one end of the USB cable to an available full speed USB
port on your PC and the other end to
EZ-KIT Lite board.
ADSP-21262 EZ-KIT Lite Evaluation System Manual
on the EZ-KIT Lite board.
J7
) is on. Also verify
LED10
and ) go on for a moment
LED9 LED12
are continually blinking.
LED8–1
on the ADSP-21262
P4