A warning pops up to inform that the user settings will be lost.
•
Select Yes to restore the production settings, select No to abort the procedure.
8.5.6.3 Program Inputboard
Use this command to program the input board. This procedure is recommended e.g. when replacing the Pico2+
board!
OverView D 50" – DOC-3303-5 – installation manual – Revision 10 – September 2006
September 2006 ________________________________
________________________________________________________
________________________________
________________________________
September 2006
September 2006
8. Final Adjustment and Configuration
warning about the loss of the user settings
Servic|Maintenance|Porgram Input Board
________________________ 8-29
________________________
________________________
Figure 8-39
Figure 8-40