Barco OVERVIEW D 50" Installation Manual page 41

The following pictures show a sketch of the installed wall fixation on the display wall:
Item no. quantities
1 2
6 2
5 1
2 4
12 4
4 1
7 2
8 2
To install the wall fixation at the display wall, proceed as follows:
•
Take the fixation bracket [5] and attach it to the profiles of the dark box (linear setup!!) using the screws
M6x40 [12] and the washers U-6-125 [2] (4 screws). In case of a curved setup, the center of the bracket is
fixed to the polygonal connection bracket with 2 screws.
•
Position the profiles [1] and apply the bushings [4] (either on top of the profiles as shown in the drawing, or
beneath the profiles).
•
Insert the screws M10 [6].
•
Use the washers [8] and nuts [7] to fix it.
OverView D 50" – DOC-3303-5 – installation manual – Revision 10 – September 2006
Description
Profile (length: project specific)
Screw M10x110
Fixation bracket display wall side
Washer U-6-125
Screw M6x40
Distance bushing
Nut M10
Washer U-10-125
September 2006 ________________________________ _________________________________________________________
________________________________ ________________________________
September 2006 September 2006
5. Wall fixation
Figure 5-6
wall fixation, A-shape
_________________________ 5-4
_________________________ _________________________