Barco OVERVIEW D 50" Installation Manual page 109

To change the specified runtime:
•
Move the cursor key to the respective field.
•
Enter the new value by means of the numeric keys of the IR Remote-Control.
in Hot Standby mode. the warning pops up if the operation time of one of the lamps
exceed the specified value.
In Cold Standby mode: the warning pops up if the operation time of the active lamp
exceeds the specified value.
8.5.13.5 Lamp Top Serial Number / Lamp Bottom Serial Number
This menu allows to change the serial number of the currently used lamp, and should be used in conjunction
with the menu Write Lamp Runtime as mentioned above.
Use these commands when exchanging lamps within a Display Wall.
OverView D 50" – DOC-3303-5 – installation manual – Revision 10 – September 2006
September 2006 ________________________________ ________________________________________________________
________________________________ ________________________________
September 2006 September 2006
8. Final Adjustment and Configuration
Enter serial number (after lamp exhange)
________________________ 8-41
________________________ ________________________
Figure 8-62