Barco OVERVIEW D 50" Installation Manual page 31

Mark the static screen!
The static screen defines the movability of all screens in a display wall.
Dismounting a screen requires the knowledge of it's movability, cf.
seamless
OverView D 50" – DOC-3303-5 – installation manual – Revision 10 – September 2006
screens
September 2006 ________________________________
September 2006 September 2006
3. Installation of Screen Module
When all screws have been applied and fixed,
place the screen module on the guide pins on
the front of the dark box. Be careful to ensure
that the edges of the screens are not damaged.
Screw on the screen module with an hexagon
key size 5 mm (torque 1-2 NM).
The picture on the right shows tightening one
of the screws at the bottom.
Try to fix the screen centered to the darkbox
(visual check)
Tighten all 4 screws!
Completely remove
movement screws.
The static screen itself and also the projection
module equipped with the static screen has to
be labeled! Wrt screen, put the label between
the two facilites to block horizontal mevement.
For the label and the position of the label on
the profile see picture on the right!
It is mandatory to stick to the rule mentioned
above and also to put on the label.
In case the screens have to be removed (either
the display wall has to be de-installed, or
either a screen has to be replaced) there is a
high risk of crashing all screens if the static
screen is not known!
_________________________________________________________
________________________________ ________________________________
Step3
the two horizontal
Step4
De-mounting the
_________________________ 3-7
_________________________ _________________________