Barco OVERVIEW D 50" Installation Manual page 81

The ASIC needs to know the uncorrected color coordinates for red, green, blue and white as well as the relative
lumens of each color.
On the Color Coordinate Adjustment dialog this information is related to Measured.
(CAST provides this information by measuring the factory colors).
The ASIC then needs to know the target color coordinates for all primary colors, for all secondary colors, and for
white (R, G, B, C, M, Y, W: "7 primary colors processing")
On the Color Coordinate Adjustment dialog this information is related to Desired
(CAST provides this information by determining the Target)
OverView D 50" – DOC-3303-5 – installation manual – Revision 10 – September 2006
September 2006 ________________________________ ________________________________________________________
________________________________ ________________________________
September 2006 September 2006
8. Final Adjustment and Configuration
Chromaticity diagram, CIE 1931
________________________ 8-13
________________________ ________________________
Figure 8-17