Barco OVERVIEW D 50" Installation Manual page 87

8.5.4.4 Set Brightness
Before setting brightness, it is recommended that Lamp Optimization, (cf.
Optimization) has been performed at least once per lamp!
Use this menu to switch between a relative brightness setting and an absolute brightness setting.
Per factory default, in new systems the value is set to relative (no brightness
information about the used lamp is available).
In running system, the correct setting is absolute brightness (measured by means of the
DIS sensor, and the target value should be the same for all projection modules of the
configuration in order to ensure a homogeneous brightness distribution.
Changing the brightness setting, requires the following steps:
•
Move to Service | Color/Brightnes | Set Brightness
•
Press Enter to select.
The following dialog box is displayed to show/to select the brightness setting and to see/change the
corresponding values.
Set Brightness, Relative (uncontrolled mode)
In this mode, Value refers to a percentage of the maximum brightness. This value corresponds to a specific
position of the Optical Dimmer (the position is determined by means of a look up table, cf.
source not found. source not source not found. source not found. found.). As mentioned above, per factory default brightness is set to Relative, and the dimmer is set
to allow maximum brightness (100%).
In this operation mode, the entries of the Brightness menu are grayed out, since these refer to absolute values!
OverView D 50" – DOC-3303-5 – installation manual – Revision 10 – September 2006
September 2006 ________________________________ ________________________________________________________
________________________________ ________________________________
September 2006 September 2006
8. Final Adjustment and Configuration
dialog box Set Brightness, relative mode activated
Brightness menu entries are grayed out
________________________ 8-19
________________________ ________________________
Lamp
Figure 8-23
Error! Reference Error! Reference Error! Reference Error! Reference
Figure 8-24