Barco OVERVIEW D 50" Installation Manual page 96

8.5.6.2 Restore Default Settings
By means of this command, the settings stored in production can be applied again.
Restoring can be done for the projection unit and for the illumination unit.
After the Restore command for the respective device, all adjustments will be lost!
To restore the parameters set in production:
•
Move the cursor key to highlight Restore Default Settings.
•
Press Enter to select.
A selection box shows up to select the device which settings should be restored:
•
Move the cursor key to highlight the desired device.
•
Press Enter to select.
OverView D 50" – DOC-3303-5 – installation manual – Revision 10 – September 2006
select the device to restore its default production settings.
September 2006 ________________________________ ________________________________________________________
________________________________ ________________________________
September 2006 September 2006
8. Final Adjustment and Configuration
________________________ 8-28
________________________ ________________________
Figure 8-38