Table of Contents
Advertisement
This procedure optimizes the coupling of the active lamp into the optical system of the
projector and is immediately triggered by selecting the command Lamp Optimization.
During this procedure, the display gets dark for about 30seconds.
•
Use the cursor keys to highlight Lamp Optimization
•
Press ENTER to select.
If Operation|Message Box is enabled, the following message box is displayed:
The procedure should be performed subsequently for both lamps.
All other steps to configure the system have to be done in the service menu.
OverView D 50" – DOC-3303-5 – installation manual – Revision 10 – September 2006
September 2006 ________________________________
_________________________________________________________
________________________________
________________________________
September 2006
September 2006
8. Final Adjustment and Configuration
Lamps menu, Lamp optimization
Lamp optimization in progress
_________________________ 8-5
_________________________
_________________________
Figure 8-6
Figure 8-7
Advertisement
Table of Contents
