Barco OVERVIEW D 50" Installation Manual page 39

To install the wall fixation at the display wall, proceed as follows:
•
Take the fixation bracket [4] and attach it to the profile of the dark box (linear setup of the display wall)
using the screws M6x40 [1] and the washers U-6-125 [5]. In case of a polygonal setup, the bracket is
attached to the polygonal connection bracket.
•
Position the profile [7] and apply the bushing [8] (either on top of the profile as shown in the drawing, or
beneath the profile).
•
Insert the screw M10 [9].
•
Use the washer [11] and nut [10] to fix it.
The following picture shows a sketch about the fixation on the wall of the building:
Attach the wall fixation bracket to the end of the profile by means of M10x85. Use the spring washer and nut to
fix it.
•
Position the bracket at the wall of the building, and mark the position to drill the holes.
•
Remove the profile from the bracket to be attached to the wall of the building (otherwise drilling and
fixation is very difficult!).
•
Use two dowels FUR 10 to attach the fixation bracket to the wall of the building.
•
Reattach the profile to the bracket now fixed to the wall of the building.
OverView D 50" – DOC-3303-5 – installation manual – Revision 10 – September 2006
connection bracket, fixation points for linear wall fixation
September 2006 ________________________________ _________________________________________________________
________________________________ ________________________________
September 2006 September 2006
5. Wall fixation
wall fixation, side of wall of the building
_________________________ 5-2
_________________________ _________________________
Figure 5-3
Figure 5-4