Barco OVERVIEW D 50" Installation Manual page 46

Pos Description
A Main Power
B
Rocker switch On/Res. with LED
C Rocker switch active Lamp
D LEDs (L1, L2, Fan)
E LED lamp door
F Position of guide pins
G Position of securing screws
Due to the keyholes, the securing screws might already be pre-installed.
Loosen the securing screws (see Figure 6-2) slightly and move them about 5 mm downwards
Tighten the securing screws.
OverView D 50" – DOC-3303-5 – installation manual – Revision 10 – September 2006
Pos Description
1 Connectors
2
Optical interface
3 Cooling air outlet
4 Cover lamp top (lamp 1)
5 Cover lamp bottom (lamp 2)
September 2006 ________________________________ _________________________________________________________
________________________________ ________________________________
September 2006 September 2006
6. Installation of Projection System
Overview illumination unit
_________________________ 6-4
_________________________ _________________________
Figure 6-5
Table 5