Pos
A
B
C
Tighten the securing screws [B].
Make sure that the screws fit tightly! Especially the mid screw of the upper row!
A tight fitting is mandatory for a stable adjustment!
Remove the protective cover [C] and install the cooling hose.
OverView D 50" – DOC-3303-5 – installation manual – Revision 10 – September 2006
Description
Position of guide pins
Position of securing screws
Protective cover
September 2006 ________________________________
September 2006
September 2006
6. Installation of Projection System
_________________________________________________________
________________________________
________________________________
Figure 6-8
Projection unit installed
Table 7
Figure 6-9
Cooling hose installed
_________________________ 6-7
_________________________
_________________________