Fault Troubleshooting - Champion 64 PRO Series Operation, Cleaning And Maintenance Manual

Faults
FAULTS
- continued
The following faults are usually handled by the operator:
DOOR OPEN
A door is open. Check the section where the door icon appears. Inspect the
door magnet and switch. Make sure door is fully closed. The door icon should disappear
and the machine continue operation once the door is closed.
CONVEYOR FULL
TOUCH TO RESET
table, then 'TOUCH TO RESET' on the status bar to clear the fault. Return to normal operation.
CONVEYOR JAM
TOUCH TO RESET
Open the doors and clear the jam, then 'TOUCH TO RESET' on the status bar to clear the fault.
Return the machine to normal operation.
WASH TANK FLOAT FAULT
by a yellow triangle in the affected tank section. Check the float and correct the problem. Then
'TOUCH TO RESET' to return the machine to normal operation.

FAULT TROUBLESHOOTING

The following faults may require troubleshooting guidance and/or service agent help:
28
The unload table is full. Remove dish racks at the end of the
Something has jammed the conveyor and it has stopped.
There is a problem with a wash tank float indicated
TOUCH TO RESET
The phone icon will access the service technician phone
number so the operator can call for assistance to fix a
problem.
Call the service agent to fix a problem as soon
as possible.
The operator should push the yellow triangle
to access the troubleshooting guide.
Presing the acknowledge icon will allow the
machine to operator after troubleshooting.
Call a service agent as soon as possible to fix
the problem.
(See next page)