Supplied Parts - Quick BTAC Series User Manual

2 - Supplied parts

2.0 - Fornitura di serie e materiale incluso nella confezione
• AC Thrusters
• Drilling template
• Gasket
• O-ring (for assembly) - (only 250-300-513)
• User's manual
• Conditions of warranty
2.1 - Needed tools for installation
BTAC 250 • Drill and drill bits Ø 11 mm (7/6") • Hole saw Ø 46 mm (1" 13/16)
• Hex keys 4 mm, 5 mm, 8 mm e 10 mm • wrench 24 mm
BTAC 300 • Drill and drill bits Ø 15 mm (19/32") • Hole saw Ø 53 mm (2" 3/32)
• Hex keys 4 mm, 5 mm, 8 mm e 12 mm • wrench 27 mm
BTAC 386 • Drill and drill bits Ø 16 mm (4" 5/8) • Hole saw Ø 120 mm (4" 23/32)
• Hex keys 4mm, 6mm 5 mm, 8 mm e 14 mm • wrench 27 mm
BTAC 513 • Drill and drill bits Ø 18 mm (45/64") • Hole saw Ø 140 mm (5" 33/64)
• Hex keys 5 mm, 8 mm e 14 mm • wrench 32 mm
2.2 - Quick recommended accessories
®
• TCD 1022 • AC POWER
• TCD 1062 • INVERTER
• TCD 1042 • AJ1
• TCD 1044 • PCS TJ1
3 - Introduction
3.0 Important notes
This manual contains Warning and/or Caution symbols that are important for safety.
Comply with the recommendations provided herein.
Warning symbol concerning hazardous
situations.
This document contains the instructions that are necessary for boat manufacturers and
marine equipment installers to assemble and commission the Thrusters.
3.1 Precautions for the installer
PROCEEDING WITH THE INSTALLATION IN GOOD LIGHT CONDITIONS.
We recommend using an appropriate personal protective equipment.
Quick thrusters are not suitable for installation in potentially explosive environments and/or atmospheres.
®
Assembly and subsequent checks or repairs must only be carried out by qualified personnel.
• PCS TJ2
• PCS TJ3
• PCS DTW
INSTALLATION AND USE MANUAL BTAC SERIES - REV000A
F
Caution symbol to avoid direct or
indirect damage to the product.
BTAC Series
BTAC series
5
EN