Supplied Parts; Tools Needed For Installation - Quick BTR140 Series Installation And Use Manual

2 - Supplied parts

2 - Supplied parts
2.0 - Standard supply and parts contained in the package
• Retractable thruster
• O-ring
• Hinge
• Lid bracket
• Steel cable
• Installation and use manual
• Conditions of warranty

2.1 - Tools needed for installation

• Phillips screwdriver
• Cutting nipper
• Drill and drill bits Ø 8,5 mm
• Hexagonal wrenches 2,5 mm
• Fork or polygonal key 8 mm and 13 mm
2.2 - Quick accessories for activation
®
of the retractable thruster
• Remote control TCD 1022
• Remote control TCD 1042
• Remote control TCD 1044
• Remote control TCD 1062
with integrated line switch control
• Thruster main switch command TSC
• Thruster main switch TMS
• TFH3 fuseholders
• TFH6 fuseholders
3 - Safety
3.0 - Warnings
• The thruster Quick
• Do not use these appliances for other uses.
• Quick shall accept no responsibility for direct or indirect damages caused by improper use of the appliance or an
®
improper installation.
• The thruster is not designed for maintaining loads generated in particular atmospheric conditions (storms).
• It is strongly recommended to entrust a professional with the positioning and presetting of the counter flange on
the hull. These instructions are generic, and do not show by any means the details of the operations of presetting the
counter flange, which falls under the competence of the shipyard. In case of problems caused by a defective installa-
tion of the tunnel, the installer will be held responsible.
• Do not install the electric motor near easily inflammable objects.
have been designed and manufactured for nautical use.
®
BTR140 INSTALLATION AND USE MANUAL - REV002A
CONTROL PANELS
TCD 1022 TCD 1042 TCD 1044
TSC THRUSTER
MAIN SWITCH
COMMAND
TFH3 - TFH6 FUSEHOLDERS
BTR140
EN
TCD 1062
BOW
STERN
TMS THRUSTER MAIN SWITCH
BTR140
25