Quick BTAC Series User Manual page 10

5 - Installation
Fig.G
• Insert two o-rings into the special
seats inside the flange.
Fig.G BTAC 250/300
5.3.0 - Gearleg and motor support flange
BTAC 250/300
• Proceed with fitting the gearleg with
the special seal gasket.
• For further protection against the entry
of water, apply silicone for nautical
use around the point of contact between
flange and tube.
• Fasten everything to the flange using
the special screws.
• Grease the terminal part of the gearleg shaft; fit the
small key into its seat.
• Grease the terminal part of the gearleg shaft.
10
INSTALLATION AND USE MANUAL BTAC SERIES - REV000A
• Insert the elastic joint in the terminal part of the
gearleg shaft.
• Insert the motor onto the elastic joint. Secure with
four screws and four washers.
BTAC Series
EN