Table of Contents
Advertisement
6 - Connection diagram
F
Use shielded cables to connect the inverter
to the motor.
MOTOR
MODEL
POWER
BT250AC200
15 kW
BT300AC300
15 kW
BT300AC350
22 kW
BT386AC420
30 kW
BT386AC460
37 kW
BT513AC1000
75 kW
*this data refer to S3 operating mode (periodic intermittent duty) - for any modification please contact Quick
7 - Warnings
7.0 - Warnings
WARNING: This thruster is not designed for a continuous use. It is equipped with protections which limit its operation at
a maximum time span, as reported on the controls' manual.
It is strongly forbidden to bypass or modify such protections in order to increase the operating time span, under pain of
voiding the warranty and thus lifting any responsibility from Quick
WARNING: Make sure no swimmers or floating objects are in the vicinity before switching on the thruster.
WARNING: There must not be flammable materials in the peak or in the area where the Thruster motor is.
WARNING: Do not operate the bow thruster out of the water for more than 10 seconds.
WARNING: During docking, it is recommended not to leave in the water any free rope, which may be sucked in by the propellers,
thus leading them to break.
16
3 380...690 Vac
INVERTER
ABSORPTION ON
VOLTAGE
POWER
GENERATORS*
400 V
15 kW
400 V
15 kW
400 V
22 kW
400 V
37 kW
400 V
37 kW
400 V
75 kW
INSTALLATION AND USE MANUAL BTAC SERIES - REV000A
19 kW
21 kW
27 kW
35 kW
40 kW
90 kW
BTAC Series
MOTORE
BTAC series
RH
NOTE: the bow thruster must be installed with
the RH propeller on the right-hand side of the
gearleg (see figure).
EN
Advertisement
Table of Contents
