Supplied Parts; Tools Needed For Installation - Quick BTQ125 Installation And Use Manual

2 - Supplied parts

2.0 - Package contains the following parts
• Thruster
• Drill template
• Gasket
• O-ring (for assembly)
• Installation and use manual
• Conditions of warranty

2.1 - Tools needed for installation

• Drill and drill bits Ø 6 mm (15/64")
• Hollow mill Ø 25 mm (1")
• hexagonal male key 4 mm, 5 mm and 6 mm
• Fork or polygonal key 10 mm
2.2 - Quick accessories for activation
®
of the retractable thruster
• Remote control TCD 1022
• Remote control TCD 1042
• Remote control TCD 1044
• Remote control TCD 1062
with integrated line switch control
• Thruster main switch command TSC
• Thruster main switch TMS
• THF3 fuseholders
3 - Safety
3.0 - Warnings
• Quick Thrusters have been designed and constructed only for nautical use.
®
• Do not use these appliances for other uses.
• Quick shall accept no responsibility for direct or indirect damages caused by improper use of the appliance or an
®
improper installation.
• The Thruster is not designed to maintain loads generated in particular atmospheric conditions (storms).
• We recommend you entrust preparation and positioning of the tube on the hull to a skilled professional. These are
generic instructions and do not give details of the preparatory operations for installing the tunnel, since this is the
competence of the boatyard. The installer shall bear full responsibility for any problems caused by defective instal-
lation of the tunnel.
• Do not install the electric motor near easily inflammable objects.
BTQ110-125 INSTALLATION AND USE MANUAL - IT EN - REV004A
BTQ110/125
CONTROL PANELS
TCD 1022 TCD 1042 TCD 1044
TSC THRUSTER
MAIN SWITCH
COMMAND
TMS THRUSTER MAIN SWITCH
TFH3 FUSEHOLDERS
EN
TCD 1062
BOW
STERN
BTQ110/125
19