Quick BTAC Series User Manual page 11

5 - Installation
5.3.1 - Piede del riduttore e la flangia di supporto motore
BTAC 386
• Proceed with fitting the gearleg with the special seal gasket.
• For further protection against the entry of water, apply silicone for nautical use around the point of contact between flange
and tube.
• Fasten everything to the flange using the special screws.
• Grease the terminal part of the gearleg shaft; fit the small key into its seat.(fig.2)
Gearleg and motor support flange
5.3.2 -
BTAC 513
fig.I
• Fig.I Apply to the gearleg the special seal gasket.
• Fig.E Remove the lid on the gearbox and insert the connection
to subsequently connect the oil tank. Screw on and turn the
connection's head towards the center, in order to ease the cou-
pling with the flange.
• Fig.F Proceed with fitting the gearleg. For further protection against the entry of water, apply silicone for nautical use around
the point of contact between flange and tube. Fasten everything to the flange using the special screws.
fig.E
INSTALLATION AND USE MANUAL BTAC SERIES - REV000A
BTAC Series
fig.F
EN
11