Chapter5 Output Commands; Output[:State][:All]; Output:series[:State]; Output:parallel[:State] - ITech CalPower IT6302 Programming Manual

OUTPut[:STATe][:ALL]

This command is used to control the output switch state.
Command syntax
OUTPut [:STATe] <bool>
Arguments
0|1|ON|OFF
*RST Value
OFF
Query syntax
OUTPut:STATe[:ALL]?
Returns
0|1

OUTPut:SERies[:STATe]

This command can set the serial state of CH1+CH2.
Command syntax
OUTPut:SERies[:STATe]
Arguments
0|1|ON|OFF
Query syntax
OUTPut:SERies[:STATe]?

OUTPut:PARAllel[:STATe]

This command can set the parallel state of CH1+CH2.
Command syntax
OUTPut:PARallel [:STATe]
Arguments
0|1|ON|OFF
Query syntax
OUTPut:PARAllel[:STATe]?

Chapter5 Output Commands

Copyright© Itech Electronics Co., Ltd.
Output Commands
20