13.9
Removing the lower triple clamp
The second milled groove (from the top) is flush with the
upper edge of the upper triple clamp.
–
Tighten screws
Guideline
Screw, top triple clamp
–
Tighten screws
Guideline
Screw, bottom triple
clamp
M01842-11
–
Position the brake caliper, mount screw
Guideline
Screw, front
brake caliper
–
Mount and tighten screw
Guideline
Screw, front
brake caliper
M01843-10
–
Position the brake line and the clamp. Mount and tighten
6
screws
.
Guideline
Screw, brake line
clamp on fork
protector
Finishing work
–
Install the front wheel.
Preparatory work
–
Raise the motorcycle with a lift stand. (
–
Remove the front wheel.
–
Remove the fork legs.
–
Remove the start number plate. (
–
Remove front fender. (
Main work
–
1
Remove nut
–
Remove the cable tie on the magnetic switch cable from the handle-
bar.
–
2
Release screw
bar and set aside.
Info
Cover the components to protect them against damage.
M01844-10
Do not kink the cables and lines.
SERVICE WORK ON THE CHASSIS 13
2
.
M8
20 Nm (14.8 lbf ft)
3
.
M8
15 Nm (11.1 lbf ft)
4
, and tighten.
M8x60
20 Nm (14.8 lbf ft)
5
.
M8x40
20 Nm (14.8 lbf ft)
EJOT PT
®
2 Nm (1.5 lbf ft)
K60x20‑AL
(
p. 73)
p. 42)
(
p. 73)
(
p. 44)
p. 49)
p. 50)
.
, take off the upper triple clamp with the handle-
Loctite
®
243™
Loctite
®
243™
45