Adjusting The Chain Guide; Checking The Frame; Checking The Link Fork; Checking The Rubber Grip - GAS GAS MC-E 5 Owner's Manual

13.27

Adjusting the chain guide

Info
The size of the chain wheel varies with the number of teeth. The chain guide can be adjusted on small sprockets.
13.28

Checking the frame

13.29

Checking the link fork

13.30

Checking the rubber grip

–
Remove screw
–
Position the chain guide.
–
Mount and tighten the screw.
Guideline
Remaining screws,
chassis
M01693-10
–
Check the frame for cracks and deformation.
» If the frame exhibits cracks or deformation due to a mechanical
impact:
–
Change the frame.
M01652-01
–
Check the link fork for damage, cracking, and deformation.
» If the link fork shows signs of damage, cracking, or deformation:
–
Change the link fork.
F02202-01
–
Check the rubber grips on the handlebar for damage, wear, and
looseness.
Info
The rubber grips are vulcanized onto a sleeve on the left and
onto the handle tube of the throttle grip on the right. The
left sleeve is clamped onto the handlebar.
The rubber grip can only be replaced with the sleeve or the
throttle tube.
401197-01
» If a rubber grip is damaged, worn, or loose:
–
Change the rubber grip.
SERVICE WORK ON THE CHASSIS 13
1
.
M6 10 Nm (7.4 lbf ft)
Info
Always replace a frame that has been damaged due
to a mechanical impact. Repair of the frame is not
authorized by GASGAS Motorcycles.
Info
Always replace a damaged link fork. GASGAS Motor-
cycles does not permit repairing link forks.
57