20 Troubleshooting - GAS GAS MC-E 5 Owner's Manual

20 TROUBLESHOOTING

Faults
Blink code 11
Blink code 12
Blink code 14
Blink code 24
Blink code 31
Blink code 33
Blink code 34
Blink code 41
Blink code 42
Blink code 43
Blink code 71
Blink code 72
Blink code 73
Blink code 83
Blink code 85
86
Faults are indicated by malfunction indicator lamp
signals that sound at the same time.
Tip
As a first measure for all faults, switch off the vehicle using the
On/Off button, wait 1 minute, and switch it on again.
If a fault is not eliminated by the measures specified here, or
a blink code is not listed, an authorized GASGAS Motorcycles
workshop will be happy to help you.
402136-10
Info
The pause between the signals of the 1st digit is 0.25 seconds.
The pause between the 1st and 2nd digits is 1 second.
The pause between the signals of the 2nd digit is also 0.25 sec-
onds.
The pause until the blink code repeats is 3 seconds.
Possible cause
Fault in the throttle grip
Fault in the throttle grip
Throttle grip actuated during acti-
vation
System temperature too high
Fault during charging
System temperature too high
System temperature too low
Vehicle moved during activation
Motor speed outside the permissi-
ble range
System temperature too high
Fault during charging
Fault during charging
Fault during charging
Transport mode activated
Fault during charging
1
and by acoustic
Action
–
Check the throttle grip for damage.
–
Check the throttle grip for damage.
–
Do not operate the throttle grip during
activation.
–
Allow the vehicle to cool down, clean the
cooling surfaces.
–
Disconnect the battery charger from the
vehicle and mains connection, wait 1
minute, restart the charging process.
–
Allow the vehicle to cool down, clean the
cooling surfaces.
–
Park the vehicle in a warmer environment.
–
Do not move the vehicle during activation.
–
Do not roll backward with the vehicle.
–
Allow the vehicle to cool down, clean the
cooling surfaces.
–
Disconnect the battery charger from the
vehicle and mains connection, wait 1
minute, restart the charging process.
–
Replace the charging cable.
–
Disconnect the battery charger from the
vehicle and mains connection, wait 1
minute, restart the charging process.
–
Replace the charging cable.
–
Disconnect the battery charger from the
vehicle and mains connection, wait 1
minute, restart the charging process.
–
Replace the charging cable.
–
Deactivate transport mode.
–
Disconnect the battery charger from the
vehicle and mains connection, wait 1
minute, restart the charging process.
–
Replace the charging cable.