Parameter Structure - WEG CFW-11 Series User Manual

Keypad (HMI)

4.2 PARAMETER STRUCTURE

When the right soft key ("MENU") is pressed in the monitoring mode, the display shows the first 4 groups of
parameters. An example of how the groups of parameters are organized is presented in table 4.1. The number
and name of the groups may change depending on the firmware version used. For further details on the existent
groups for the used firmware version, refer to the programming manual.
Level 0
00
Monitoring
01
4
02
03
04
05
06
07
08
09
4-4
Table 4.1 - Groups of parameters
Level 1
ALL PARAMETERS
PARAMETER GROUPS
ORIENTED START-UP
CHANGED PARAMETERS
BASIC APPLICATION
SELF-TUNING
BACKUP PARAMETERS
I/O CONFIGURATION
FAULT HISTORY
READ ONLY PARAMS.
Level 2
20 Ramps
21 Speed References
22 Speed Limits
23 V/f Control
24 Adjust. V/f Curve
25 V V W Control
26 V/f Current Limit.
27 V/f DC Volt.Limit.
28 Dynamic Braking
29 Vector Control
30 HMI
31 Local Command
32 Remote Command
33 3-Wire Command
34 FWD/REV Run Comm.
35 Zero Speed Logic
36 Multispeed
37 Electr. Potentiom.
38 Analog Inputs
39 Analog Outputs
40 Digital Inputs
41 Digital Outputs
42 Inverter Data
43 Motor Data
44 FlyStart/RideThru
45 Protections
46 PID Regulator
47 DC Braking
48 Skip Speed
49 Communication
50 SoftPLC
51 PLC
52 Trace Function
38 Analog Inputs
39 Analog Outputs
40 Digital Inputs
41 Digital Outputs
Level 3
90 Speed Regulator
91 Current Regulator
92 Flux Regulator
93 I/F Control
94 Self-Tuning
95 Torque Curr.Limit.
96 DC Link Regulator
110 Local/Rem Config.
111 Status/Commands
112 CANopen/DeviceNet
113 Serial RS232/485
114 Anybus
115 Profibus DP