Rekluse CoreEXP 3.0 Installation Manual page 36

Note: If the engine wants to stall or the creep is excessive, the
idle may be too high or the installed gap may be too small. Make
necessary adjustments before proceeding.
5. Place the bike in NEUTRAL and
recheck Free Play Gain. Continue
to adjust the installed gap until the
clutch lever is 1/8"-1/4" (3 mm-6
mm).
Note: Your clutch pack will expand with heat, so final adjustment
to Free Play Gain should be made when the bike is warm.
Remember not to ride without sufficient Free Play Gain.
Do not perform 2
Always keep the motorcycle in first gear when taking off
from a stop. Taking off from a higher gear can cause
premature clutch wear and damage the product.
DO NOT DYNO TEST YOUR MOTORCYCLE BEFORE
BREAK IN! Always break in the product before performing
dyno testing. Read the included dynamometer sheet for
more information.
Pg. 36
nd rd
and 3 gear starts with this product.
Doc ID: 191-6206A
Doc Rev: 062818
Recheck Free Play Gain
and adjust the installed
gap