Table of Contents
Advertisement
5. Install the drive gear, clutch assembly, and chain at the same
time. Do this by grasping the drive gear and clutch assembly
and firmly slide them onto their respective shafts.
6. Place a primary wedge tool between the teeth of the drive
gear and the clutch assembly gear. This will allow you to
tighten the nuts.
7. Reinstall the OE crankshaft nut by turning it clockwise, then
torque the nut to 240-260 ft-lb (325-353 N-m) per OE
specifications.
Doc ID: 191-6206A
Doc Rev: 062818
Pg. 19
Advertisement
Table of Contents
Need help?
Do you have a question about the CoreEXP 3.0 and is the answer not in the manual?