Table of Contents
Advertisement
4. Remove and set aside the OE chain inspection cover and
gasket.
Inspection cover
5. Verify that the lock nut on the chain tensioner is still loose.
Then, turn the adjustment bolt on the chain tensioner
clockwise until the drive chain has 3/8" to 1/2 of travel in it.
6. Taking care to keep the adjuster bolt from rotating, tighten the
lock nut on the chain tensioner to 20 ft-lb (27 N-m).
Pg. 26
Doc ID: 191-6206A
Doc Rev: 062818
Gasket
Advertisement
Table of Contents
Need help?
Do you have a question about the CoreEXP 3.0 and is the answer not in the manual?