Ap Has Incorrect Ip Address - Avaya AP-4 User Manual

AP Has Incorrect IP Address

1. Default IP Address Assignment mode is dynamic (DHCP). If you
do not have a DHCP server on your network, the default IP
Address is 169.254.128.132. If you have more than one
unintialized AP connected to the network, they will all have the
same default IP address and you will not be able to communicate
with them (due to an IP address conflict). In this case, assign each
AP a static IP address via the serial cable or turn off all units but
one and change the IP address using ScanTool one at a time.
2. The AP only contacts a DHCP server during boot-up. If your
network's DHCP server is not available while the AP is booting, the
device will retain the last IP Address it had. Reboot the AP once
your DHCP server is on-line again or use the ScanTool to find the
Access Point's current IP address.
3. To find the unit's current IP address if using DHCP, open the IP
Client Table in the DHCP Server and match the Access Point's IP
address to its MAC address (found on the product label).
Alternatively, use ScanTool to identify an Access Point's current IP
address.
4. Once you have the current IP address, use the HTTP or CLI
Interface to change the unit's IP settings, if necessary.
5. If you use static IP Address assignments, and cannot access the
unit over Ethernet, use the
procedure. Once the IP Address is set, you can use the Ethernet
Interface to complete configuration.
Avaya Wireless AP-4/5/6 User's Guide
Symptoms and Solutions
Initializing the IP Address using CLI
7-7