Cleaning The Trackball - GE LOGIQ V2 Basic Service Manual

General Procedures and Functional Checks

Cleaning the Trackball

WARNING
Manpower
Tools
Preparations
4-22
DO NOT touch any boards with integrated circuits prior to
taking the necessary ESD precautions.
Always connect yourself, via an arm-wrist strap, to the advised
ESD connection point located on the rear of the Ultrasound
system (near the power connector).
Follow general guidelines for handling of electrostatic sensitive
equipment.
One person, 5 minutes,
• Antistatic brush and/or antistatic vacuum cleaner
To get access to the trackball for cleaning, you must perform the
following steps:
1. Power down the system.
2. Disconnect the mains power cable from the wall outlet.
Follow these links if you need more information: See 'Power off'
on page 4-9 for more information.
LOGIQ V2/LOGIQ V1 – Basic Service Manual
5610739-100 English Rev.10